Magnetisation Grade: N35
Magnet Material: Neodymium-Iron-Boron (NdFeB, Neo)
Magnet ID: RMS-IT-88-N35
Plating / Coating: Rubber or Plastic Jacket
Shape: Magnetic systems with Internal Thread
Magnetic systems Magnet Size:
Total weight 186 g
Total height H 8.5 mm
Total diameter D 88 mm
Thread standard m M6
Tolerance: ±0.05 mm
Magnetisation Direction: Axial / Diametrical
Residual Magnetic Flux Density (Br): 1170-1220 mT (11.7-12.2 kGs)
Energy Density (BH)max: 263-287 KJ/m³ (33-36 MGOe)
Coercivity Force (Hcb): ≥ 868 kA/m ( ≥ 10.9 kOe)
Intrinsic Coercivity Force (Hcj): ≥ 955 kA/m ( ≥ 12 kOe)
Maximum Operation Temperature: 80 °C
Delivery Time: 14-35 days
Measurements:
Threaded Through Hole
An introduction to Threaded Through Hole
Threaded Through Hole
The Pot Magnet with Threaded Through Hole Mounting consists of a steel disc with a ring milled out for a ring magnet to be inserted plus a tapped through hole to allow a M4, M6 or M8 threaded bar or bolt to be screwed through. The design is compact and extremely robust. The through hole allows the possibility of a bolt or threaded bar to be screwed past the magnet face to prise the Pot Magnet with Threaded Through Hole Mounting away from the structure to which it is magnetically held against.
The Pot Magnet with Threaded Through Hole Mounting uses ferrite magnets and the steel casing is zinc or chrome plated for corrosion protection. The ferrite Pot Magnet can be used up to +180 degrees C but may start to show some signs of weakening (demagnetisation) when used in sub-zero conditions e.g. -10 to -20 deg C but the actual design and application determines at what temperature demagnetisation may be noticed.
We also offer a Pot Magnet with Threaded Through Hole Mounting with a Stainless Steel (SS304) casing. This does not require any plating and is naturally corrosion resistant.
The Pot Magnet with Threaded Through Hole Mounting range exists in 25mm to 80mm diameter size with maximum pull forces from 3.6kg up to 55kg.
