Bar magnet SmCo, brass body with fitting tolerance h6.
Magnet ID:              SDPB-3240

Material: Circular rods made of SmCo and brass body
Plating / Coating:  brass
Shape:         Bar / Rod
Tolerance:           D ±0.1 mm / H ±0.2 mm
Magnetisation Direction:    anisotrop
Maximum Operation Temperature: 280 °C 
Delivery Time:           14-35 days
Article number         D mm                H mm         A¹ mm     Distance mm      Force* N       Weight g      Temperature °C
SDPB-3240            32              40(+0.3/-0.3)        4.5                6.0                    600                  251                  200        
        
Measurements:

For best use of the deep pot holding magnets, it is recommended not to insert them flush into a steel housing, but to leave them projecting by about 2 mm. It is also sufficient to countersink the space around the system by a clearance of about 3 to 4 mm width. A sleeve made from un-magnetized material, e.g. aluminum, brass or plastic is also recommended. If it is only possible to install them in steel directly, a holding force reserve of 30 % must be considered when choosing the size.Non-active face can be drilled & tapped to a maximum depth as shown in dimension X.